90° Elbow
6 inch 90 Degree Elbow - 3D Printed Dust Collection Fitting
SKU: GD-FIT-E90-6IN
Not for sale yet
This one is made to order in our large-part run. Join the list for it.
Build this adapter on demand
We print to order. Drop your email and we add you to the list for this part.
Printed to standard 6 inch (152.4 mm) duct size. It pushes on and holds in most setups.
- Standard sizesStandard size shown
- Made in the USAPrinted to order
- Flat $7.95 shippingOne rate, anywhere in the US
- PETG, not brittle PLABuilt for the shop
About This Fitting
3D printed 6 inch 90 degree elbow for dust collection. Smooth interior, fits standard 6 inch ductwork.
The ends are printed to standard duct sizes, so they push together and hold in most setups. Printed in PETG, made to order in the USA. Why we use PETG.
What You Get
- One PETG 90° elbow for 6 inch duct
- Smooth inside walls, so air keeps moving and you lose less pull
- Ends printed to a standard duct size, so it pushes on and holds in most setups
- Made to order in the USA, then shipped to you
How it fits
- 1
Push each end onto your 6 inch duct or hose.
- 2
Twist a little so the ends seat.
- 3
Add a wrap of tape at any joint that sees heavy use.
- 4
Run your dust collector and the air routes clean.
Size help
Measure your hose or duct first, in inches or millimeters. Our measuring guide shows how.
Common questions
Will it fit my duct?
It is sized for 6 inch duct. Every opening on it is printed to those numbers.
Do I need clamps or tape?
The joint holds on its own in most setups. For a joint that sees heavy use or pulls high suction, a wrap of foil tape locks it down.
What is it made of?
PETG, the same plastic on every part we make. Our About page says why.
Do you sell the design file?
No. We sell the finished part. We print it to order and ship it to you from the US.
Build the adapter for your two sizes
Measure your tool and your vac, so more dust goes in the vac and less in the air you breathe.
Build My Adapter