Wye Splitter
6 inch to 5 inch Wye Splitter - 3D Printed Dust Collection Fitting
SKU: GD-FIT-WYE-6IN-5IN
Made to order
This one is made to order in our large-part run. Join the list for it.
Build this adapter on demand
We print to order. Drop your email and we add you to the list for this part.
Friction fit ends, so it pushes onto your duct with no clamps in most setups.
Printed to 6 inch duct with a 5 inch branch.
- Made to fit your toolFriction fit, no clamps
- Made in the USAPrinted to order
- Flat $7.95 shippingOne rate, anywhere in the US
- PETG, not brittle PLABuilt for the shop
About This Fitting
3D printed wye splitter with 6 inch trunk and 5 inch branch.
It is printed in PETG, so it stands up to shop heat and solvents and will not crack like brittle PLA. The ends are a friction fit, so they push together with no clamps in most setups. Every part is made to order in the USA.
What You Get
- One PETG wye splitter for 6 inch duct
- Smooth inside walls, so air keeps moving and you lose less pull
- Friction fit ends, so it pushes on with no clamps
- Made to order in the USA, then shipped to you
How it fits
- 1
Push each end onto your 6 inch duct or hose.
- 2
Twist a little so the friction-fit ends seat.
- 3
Add a wrap of tape at any joint that sees heavy use.
- 4
Run your dust collector and the air routes clean.
Settle the size
Two ways to land on the right number.
1. Measure it yourself
Calipers or a ruler in millimeters. That number is what the builder asks for, and we print to it.
How to measure both ends
First look at the port on your tool. Most are an opening you can put a caliper tip inside. Some are a stub that sticks out, the kind a hose slips over. The two need different numbers, so check which one you have before you measure.
If the port is an opening, measure the inside. Put your calipers in the opening and open them until they touch both walls. That inside number is the one our parts are built to, because our adapter goes into the port.
If the port is a stub the hose slips over, measure across the outside of the stub. Our adapters today are male on both ends, so they go into an opening rather than over a stub. That means a stub port may need a different part than the ones we list, so ask us before you order.
Do the same at the vacuum end. Measure the inside of the open hose or duct end. With both numbers written down, the chart and the builder both know what to show you.
2. Put your setup on the record
Give us two numbers and we build to them.
Common questions
Will it fit my duct?
It is sized for 6 inch duct with a 5 inch branch. Every opening on it is printed to those numbers.
Do I need clamps or tape?
The friction fit holds on its own in most setups. For a joint that sees heavy use or pulls high suction, a wrap of foil tape locks it down.
What is it made of?
PETG. It handles shop heat and common shop solvents and takes knocks without cracking like brittle PLA.
Do you sell the design file?
No. We sell the finished part. We print it to order and ship it to you from the US.
Find the adapter that fits your tool
Pick your tool and your vac, so more dust goes in the vac and less in the air you breathe.
Find my adapter