Under-Cabinet Dust Port
Under-Cabinet Floor Sweep with 4 inch Duct Connection with Blast Gate
SKU: GD-FS-UC-4-BG
- 4 inNot for sale yet (this size)
- 5 inNot for sale yet
- 6 inNot for sale yet
Not for sale yet
This one is made to order as a two-part set. Join the list for it.
Build this adapter on demand
We print to order. Drop your email and we add you to the list for this part.
Sweep debris to the duct, so you skip the dustpan and the cleanup.
- Standard sizesStandard size shown
- Made in the USAPrinted to order
- Flat $7.95 shippingOne rate, anywhere in the US
- PETG, not brittle PLABuilt for the shop
About This Floor Sweep
Sweep the floor straight into your dust collector, so you skip the dustpan and the bending over. This under-cabinet dust port connects to 4" duct, so the mess goes right where your system already pulls. The intake opening runs about 150mm by 40mm. Measure the spot you want it in and match it to that opening.
This listing names a blast gate. The part has a slot where a gate would go, but we do not make the gate plate, so this sweep is not for sale yet. Pre-drilled holes let you screw it down in minutes. Printed in PETG, made to order in the USA. Why we use PETG.
What You Get
- One PETG under-cabinet dust port with a 4" duct connection
- A wide intake, so a push broom clears the floor in one pass
- A slot where a gate would go. No gate plate is made, so it is not for sale yet
- Pre-drilled mounting holes, so it screws down in minutes
How it fits
- 1
Mount it at floor level near your 4" duct run.
- 2
Connect your 4" duct to the back port.
- 3
Open the blast gate when you want to sweep.
- 4
Sweep the dust toward the intake and it pulls right in.
Size help
Measure your hose or duct first, in inches or millimeters. Our measuring guide shows how.
Common questions
What duct size does it take?
It connects to 4" duct. Use a reducer or hose adapter if your duct run is a different size.
How do I mount it?
It comes with pre-drilled holes, so you screw it to the wall, the bench, or the baseboard in a few minutes.
Does it shut off airflow?
Not yet. The listing names a gate, but we do not make the gate plate. Add a blast gate on the duct run if you want to close it off.
What is it made of?
PETG, the same plastic on every part we make. Our About page says why.
Build the adapter for your two sizes
Measure your tool and your vac, so more dust goes in the vac and less in the air you breathe.
Build My Adapter