Adapter photos
Craftsman 10 in. Table to 2.25" Duct Adapter
Connects the Craftsman CMXETAX dust port to Standard 2-1/4 inch Duct. Friction fit, PETG, made in the USA.
Build this adapter on demand
We print to order. Drop your email and we will queue this exact fit and ship it from the US in two to three business days.
Ports vary a little by model year. Measure your tool port to confirm the size before you order.
- Sized to your exact portReal specs, not guesswork
- Made in the USAPrinted to order
- Ships in 2 to 3 daysFast and tracked
- PETG, not brittle PLABuilt for the shop
Specs and fit
Fit diagram
Tool port
2.25" Duct
About This Adapter
Catch the dust right at the tool, so it ends up in the vac and not in your lungs or all over the bench. This part connects the Craftsman CMXETAX dust port (57.15mm) to a Standard 2-1/4 inch Duct hose or fitting (57.15mm ID).
It is printed in PETG, so it shrugs off heat and shop solvents and will not crack like brittle PLA. The friction fit grips the hose, so you skip the tape and clamps in most setups.
Every adapter is printed to order and made in the USA, so you get a clean fit shipped to you in 2 to 3 business days.
What You Get
- One PETG adapter, printed to order for your exact ports
- Friction fit on both ends, so it seats with a push
- Airtight seal, so suction stays strong at the blade
- Fits standard hose sizes, so it drops into your setup
- No clamps, tape, or glue, so setup takes seconds
How it fits
- 1
Push the small end onto the Craftsman CMXETAX dust port.
- 2
Slide your 2.25" Duct hose onto the other end.
- 3
Twist a little so both friction-fit ends seat snug.
- 4
Run the tool and the dust pulls straight into the vac.
Common questions
- Will this fit my tool?
- It is sized for the Craftsman CMXETAX dust port at about 57.15mm. Ports can shift a little by model year, so measure your port first and compare it to the size shown above.
- Do I need clamps or tape?
- No. Both ends are a friction fit, so they push on and grip on their own in most setups. If your hose is worn, a wrap of tape helps.
- What is it made of?
- PETG. It handles shop heat up to about 80C, shrugs off common shop solvents, and takes drops without cracking like brittle PLA.
- Can I buy just the STL file?
- Yes. Pick the download option to print it yourself. The printed and shipped option comes made to order from the US in 2 to 3 business days.
- What if it does not fit right?
- Measure your port and reach out and we will help you find the right size. If a part shows up with a print defect we will reprint it.
Need a different fit?
This adapter is sized for the Craftsman CMXETAX paired with Standard 2-1/4 inch Duct. If you want the same tool with a different vacuum or duct size, the configurator can rebuild it in a few clicks. Your tool stays picked, you swap the output.