Adapter photos
Dimensions
Fit Diagram
Tool port
2.25" Duct
Milwaukee 2723-20 to Standard 2-1/4 inch Duct
SKU: GD-MILW-272320-G225IN
Build this adapter on demand
We print to order. Drop your email and we will queue this exact fit and ship it from the US in two to three business days.
Friction fit on both ends, so it seals tight and you skip the tape. Printed with full fill on contact surfaces for a snug, airtight grip.
- Sized to your exact portReal specs, not guesswork
- Made in the USAPrinted to order
- Ships in 2 to 3 daysFast and tracked
- PETG, not brittle PLABuilt for the shop
About This Adapter
Catch the dust right at the tool, so it ends up in the vac and not in your lungs or all over the bench. This part connects the Milwaukee 2723-20 dust port (35mm) to a Standard 2-1/4 inch Duct hose or fitting (57.15mm ID).
It is printed in PETG, so it shrugs off heat and shop solvents and will not crack like brittle PLA. The friction fit grips the hose, so you skip the tape and clamps in most setups.
Every adapter is printed to order and made in the USA, so you get a clean fit shipped to you in 2 to 3 business days.
What You Get
- One PETG adapter, printed to order for your exact ports
- Friction fit on both ends, so it seats with a push
- Airtight seal, so suction stays strong at the blade
- Fits standard hose sizes, so it drops into your setup
- No clamps, tape, or glue, so setup takes seconds
Tool specs
Weight: 2.95 lbs
Max RPM: 31,000
Cordless (battery)
Need a different fit?
This adapter is sized for the Milwaukee 2723-20 paired with Standard 2-1/4 inch Duct. If you want the same tool with a different vacuum or duct size, the configurator can rebuild it in a few clicks. Your tool stays picked, you swap the output.