Backbone system
Quick-Connect Dust Hose Clamp
One hose. Every tool. Click it on, click it off.
- Push-on, pull-off snap fit. No tools to connect.
- Springy fingers hold the hose tight on the port.
- Two pull wings for one-hand release.
- Hose spigot on the back plugs into a 2.5 inch hose.
Ships printed to order, ready to use.
- Made to fit your toolFriction fit, no clamps
- Made in the USAPrinted to order
- Flat $7.95 shippingOne rate, anywhere in the US
- PETG, not brittle PLABuilt for the shop
About This Part
This clamp clicks a hose onto a GulpDust flange or port. Push it on and it snaps. Pull it off when you want the hose at another tool. No screws, no tape, no fighting with a hose clamp.
Springy fingers open as the bead passes, then snap back and hold. Two pull wings give you a grip to pop it off with one hand.
The clamp and the flange are the backbone. Buy one clamp for your hose, then put a cheap flange on every tool. Every new station is one more flange, not a whole new setup.
Who it is for: One-hose shops that move a single hose between three to ten machines all day.
Specs
Quick-Connect Hose Clamp FAQ
How does the quick-connect clamp work?+
The clamp slips over a flange spigot. Springy fingers open as the snap bead passes, then close behind it and hold. To take it off, grip the two wings and pull.
Do I need any tools or clamps?+
No. It is push-on and pull-off by hand. There is no metal hose clamp and no tape. The snap holds it on its own.
What does it connect to?+
It connects to the GulpDust bolt-on flange and any port that carries the same snap bead. The back end is a 2.5 inch hose spigot.
